Installation Sheet

2
2
1
With the provided Allen wrench, remove the set screws both sides of the fixture base.
Remove the mounting plate from the fixture base
Install the mounting plate to the junction box with the two #8-32 screws provided.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white wire to the neutral power line with a wire nut.
Connect the black wire to the hot power line with a wire nut.
Use the gray and purple dimming wires for 0-10v dimming application (if not in use, make sure to cap these wires off). TheWarning:
purple and gray wires are only used for 0-10v dimming. For all other applications, do not connect the gray and purple wires.
Properly place all wires and wire nut connections into the junction box, mount the fixture base onto the mounting plate, and secure it in
place by reinstalling the set screws using the provided Allen wrench.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
(Optional):Remove the threaded sealing cap by unscrewing it to access the CCT toggle switch. Toggle the switch to the desired color
temperature and reinstall the threaded sealing cap.
1A
Install the Fixture
4
3
6
5
7
8
ALLEN WRENCH
& SET SCREW
MOUNTING PLATE
JUNCTION BOX
7
#8-32 SCREW
3
6
5
9
BOTTOM VIEW
SEALING
CAP
CCT
TOGGLE
10
10