Installation Sheet

1.0

Installation Instructions for

Cosmo 12/18 Wall

700OWCOS_

920OWCOSMO

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product may be dimmed with a low-voltage electronic

dimmer or a 0-10V dimmer depending on the wiring

configuration.

Suitable for wet locations.

Install the Fixture

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

With the provided Allen wrench, remove the two

mounting plate screws.

Remove the mounting plate from the back of the

fixture.

FIXTURE

SCREW

MOUNTING

PLATE

ALLEN

WRENCH

OUTDOOR

ELECTRICAL BOX

Install the mounting plate onto the electrical box with

the two #8-32 screws provided.

#8-32 SCREW

PAGE 1
920OWCOSMO Installation Instructions for Cosmo 12/18 Wall 700OWCOS_ 1.0 OUTDOOR GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product may be dimmed with a low-voltage electronic dimmer or a 0-10V dimmer depending on the wiring configuration. Suitable for wet locations.
PAGE 2
1C 1D 6 4 5 7 4 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes. 5 Connect the black fixture wire to the hot power line wire with a wire nut. 6 Connect the white fixture wire to the neutral power line wire with a wire nut. 7 Use the gray and purple dimming wires for 0-10v dimming application (if not in use, make sure to cap these wires off). 8 Properly place all wires and wire nut connections into the electrical box.