Installation Sheet

2
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2016 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
1C
Connect the mounting plate ground wire to a suitable
ground in accordance with local electrical codes.
Connect the black fixture wire to the hot power line
wire with a wire nut.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Use the gray and purple dimming wires for 0-10v
dimming application (if not in use, make sure to cap
these wires off).
Properly place all wires and wire nut connections into
the electrical box.
Mount the fixture by installing it back onto the
mounting plate and reinstalling the fixture screws
(reversal of figure 1A).
4
5
6
7
8
4
5
6
7
9
1D
For wet locations, caulk around the base with
waterproof construction sealant.
10
Warning: The purple and gray wires are only
used for 0-10v dimming. For all other
applications, do not connect the gray and purple
wires.
Note for In-Line Fuse equipped fixtures: in the
case that the fixture is not operating correctly,
make sure to check the fuse.
Note for Photocell equipped fixtures: at initial
power up, the photocell must calibrate which will
cause the fixture to cycle on/off for a moment.