Installation Sheet

ManualsBrandsTech Lighting ManualsCeiling FixturesTech Lighting Mode Single Light 25" High Integrated LED Outdoor Semi-Flush Ceiling Fixture

1.0

Installation Instructions for

Mode Single and Dual Head Ceiling or Wall

700OWMDE_

920OWMDE

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product may be dimmed with a low-voltage electronic

dimmer or a 0-10V dimmer depending on the wiring

configuration.

Suitable for wet locations.

These fixture may be ceiling or wall mounted.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Loosen (do not remove) the three set screws on the

stem using the provided Allen Wrench.

Rotate the fixture arm to the desired direction and

secure in place by re-tightening the set screws.

SET SCREW

ALLEN

WRENCH

OUTDOOR

FIXTURE ARM

Adjust the Fixture

Loosen (do not remove) the set screw on the fixture arm

using the provided Allen Wrench.

Aim the head to the desired direction and secure in

place by re-tightening the set screw. Tick marksNote:

are in intervals of 10°. Indicator is positioned to 40° in

the image above.

SET SCREW

ALLEN

WRENCH

FIXTURE ARM

INDICATOR

HEAD

STEM

Summary of content (4 pages)

PAGE 1
920OWMDE Installation Instructions for Mode Single and Dual Head Ceiling or Wall 700OWMDE_ 1.0 OUTDOOR GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product may be dimmed with a low-voltage electronic dimmer or a 0-10V dimmer depending on the wiring configuration. Suitable for wet locations. These fixture may be ceiling or wall mounted.
PAGE 2
Install the Fixture 2A 2C MOUNTING PLATE 4 FIXTURE SCREW 5 1 6 1 ALLEN WRENCH Note: When wall mounting the fixture, to prevent sagging, position the mounting plate so the fixture screws align vertically 1 Remove the canopy screws using the provided Allen Wrench. 2 Remove the mounting plate from the canopy. 2B MOUNTING PLATE ELECTRICAL BOX #8-32 SCREW 3 Mount the mounting plate to the electrical box using the provided #8-32 screws.
PAGE 3
Install or Replace Optics 3A 2D HEAD OPTIC OPTIC HOLDER 9 For wall mounted fixtures in wet locations, caulk around the base with waterproof construction sealant. 3 1 Unscrew and remove the optic holder. 2 Remove old optic and replace with new one. 3 Screw the optic holder back into the head until fully secured.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.