Installation Sheet

2
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
1E
For wet locations, caulk around the base with
waterproof construction sealant.
12
1C
Choose and drill out the designated mounting holes
that will be used to mount the mounting plate.
Use the built-in level to ensure the mounting plate is
level and secure it to the wall using the appropriate
hardware.
4
5
MOUNTING HOLE
LOCATION
4
4
4
4
4
4
4
4
5
1D
9
Connect the mounting plate ground wire to a suitable
ground in accordance with local electrical codes.
Connect the black fixture wire to the hot power line
wire with a wire nut.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Use the gray and purple dimming wires for 0-10v
dimming application (if not in use, make sure to cap
these wires off).
Properly place all wires and wire nut connections into
the fixture.
Mount the fixture by installing it back onto the
mounting plate and tightening the set screws (reversal
of figure 1A).
6
7
8
9
10
11
Warning: The purple and gray wires are only used for 0-
10v dimming. For all other applications, do not connect
the gray and purple wires.
Note for In-Line Fuse equipped fixtures: in the case that
the fixture is not operating correctly, make sure to check
the fuse.
Note for Photocell equipped fixtures: at initial power
up, the photocell must calibrate which will cause the
fixture to cycle on/off for a moment.
6
7
8