Installation Sheet

1.0

Installation Instructions for

Taag 6 Wall

700OWTAG_6_

920OWTAAG6

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product may be dimmed with a low-voltage electronic

dimmer or a 0-10V dimmer depending on the wiring

configuration.

Suitable for wet locations.

Install the Fixture

With the Allen wrench provided, back out (do not fully

remove) the set screws at the base of the fixture.

Remove the mounting plate from the back of the

fixture.

ALLEN WRENCH

SET SCREW

MOUNTING

PLATE

Use the built-in level to ensure the mounting plate is

level and secure it to the electrical box using the two

provided #8-32 screws.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

OUTDOOR

PAGE 1
920OWTAAG6 Installation Instructions for Taag 6 Wall 700OWTAG_6_ OUTDOOR GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product may be dimmed with a low-voltage electronic dimmer or a 0-10V dimmer depending on the wiring configuration. Suitable for wet locations.
PAGE 2
1D 1C 35 4 6 5 SET SCREW 10 4 Connect the backplate wire to a suitable ground in accordance with local electrical codes. 5 Connect the white driver wire to the neutral power line. 6 Connect the black driver wire to the hot power line. 7 Use the gray and purple dimming wires for 0-10v dimming application (if not in use, make sure to cap these wires off). ALLEN WRENCH Warning: The purple and gray wires are only used for 0-10v dimming.