Installation Sheet

2
1D
9
8
Properly place the wires and wire nut connections into
the fixture.
Hook the top of the fixture to the top of the mounting
plate and swing the bottom of the fixture toward the
plate until it is flush with the wall.
Tighten the set screws at the bottom of the fixture.
10
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2016 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
ALLEN WRENCH
SET SCREW
10
1C
3
6
5
4
Connect the backplate wire to a suitable ground in
accordance with local electrical codes.
Connect the white driver wire to the neutral power line.
Connect the black driver wire to the hot power line.
Use the gray and purple dimming wires for 0-10v
dimming application (if not in use, make sure to cap
these wires off).
4
5
6
7
For wet locations, caulk around the base with
waterproof construction sealant.
11
1E
Warning: The purple and gray wires are only
used for 0-10v dimming. For all other
applications, do not connect the gray and purple
wires.
Note for In-Line Fuse equipped fixtures: in the
case that the fixture is not operating correctly,
make sure to check the fuse.
Note for Photocell equipped fixtures: at initial
power up, the photocell must calibrate which will
cause the fixture to cycle on/off for a moment.
5