Installation Sheet

1.1

Installation Instructions for

Turbo Wall

700OWTUR_

920OWTURBO

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product may be dimmed with a low-voltage electronic

dimmer or a 0-10V dimmer depending on the wiring

configuration.

Suitable for wet locations.

Prepare the Fixture

With the provided Allen wrench, back out (do not fully

remove) the set screws on both sides of the fixture.

Remove the mounting plate from the back of the

fixture.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

OUTDOOR

While holding the backplate in place, remove the

backplate screws with the provided Allen wrench.

ALLEN WRENCH

BACKPLATE

Adjust the Position of the Backplate

(optional)

BACKPLATE

SCREW

MOUNTING

PLATE

ALLEN WRENCH

SET SCREW

PAGE 1
920OWTURBO Installation Instructions for Turbo Wall 700OWTUR_ 1.1 OUTDOOR GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product may be dimmed with a low-voltage electronic dimmer or a 0-10V dimmer depending on the wiring configuration. Suitable for wet locations.
PAGE 2
B 3B 4 2 3 5 2 Slide the backplate either up or down until the backplate screw holes are aligned. 3 Make sure that the gasket behind the backplate is in place and reinstall the mounting plate screws tightly in place. 2 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes. 3 Connect the black fixture wire to the hot power line wire with a wire nut. 4 Connect the white fixture wire to the neutral power line wire with a wire nut.
PAGE 3
C 8 For wet locations, caulk around the base with waterproof construction sealant.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.