Installation Sheet

2B
2
Slide the backplate either up or down until the
backplate screw holes are aligned.
Make sure that the gasket behind the backplate is in
place and reinstall the mounting plate screws tightly in
place.
3
2
3
4
5
3B
Connect the mounting plate ground wire to a suitable
ground in accordance with local electrical codes.
Connect the black fixture wire to the hot power line
wire with a wire nut.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Use the gray and purple dimming wires for 0-10v
dimming application (if not in use, make sure to cap
these wires off).
Properly place all wires and wire nut connections into
the electrical box.
Mount the fixture by installing it back onto the
mounting plate and reinstalling the fixture screws
(reversal of figure 1A).
2
3
4
5
6
7
Install the Fixture
3A
1
Attach the mounting plate to the electrical box using
the two provided #8-32 screws.
1
1
2
Warning: The purple and gray wires are only
used for 0-10v dimming. For all other
applications, do not connect the gray and purple
wires.
Note for In-Line Fuse equipped fixtures: in the
case that the fixture is not operating correctly,
make sure to check the fuse.