Installation Sheet

ManualsBrandsTech Lighting ManualsLightingVex 2 Light 5" Tall LED Outdoor Wall Sconce with Adjustable Beam Angle

1.0

Installation Instructions for

Vex Outdoor Wall

700 X_-OWVE LED

920OWVEX

OUTDOOR

Slide the cover off of the fixture.

COVER

FIXTURE

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product may be dimmed with a low-voltage electronic

dimmer or a 0-10V dimmer depending on the wiring

configuration.

Suitable for wet locations.

Unscrew and remove the knurled nuts.

Remove the mounting plate from the back of the

fixture.

MOUNTING

PLATE

KNURLED NUT

Install the Fixture

Summary of content (4 pages)

PAGE 1
920OWVEX Installation Instructions for Vex Outdoor Wall 700OWVEX_-LED 1.0 OUTDOOR GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product may be dimmed with a low-voltage electronic dimmer or a 0-10V dimmer depending on the wiring configuration. Suitable for wet locations.
PAGE 2
1C 1E #8-32 SCREW THREADED STUD THREADED STUD KNURLED NUT THREADED STUD #8-32 SCREW 4 ELECTRICAL BOX 8 Align the two mounting studs horizontally and mount the mounting plate to the electrical box with the two #8-32 screws provided. Neatly tuck all wires and wire nut connections into the electrical box, mount the fixture onto the threaded studs, and secure it in place by screwing the knurled nuts onto the studs.
PAGE 3
Adjust the Fixture 2A 1G LIP ANGLE MARKERS 10 COVER 1 1 2 ALLEN WRENCH ALLEN WRENCH & SET SCREW 11 SET SCREW 11 DRIVER HOUSING NOTE: Make sure the sealant is dry before reinstalling the cover. 10 Install the cover by sliding it back onto the fixture making sure the lips of the cover are behind the driver housing. 11 Secure the cover in place by tightening the set screws with the provided Allen wrench. 3 1 The angle markers can be adjusted independently.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.