Installation Sheet

1.1

Installation Instructions for

Voto 6 Wall

700OWVOT_6_

920OWVOTO6

Install the Fixture

With the Allen wrench provided, back out (do not fully

remove) the set screw at the base of the fixture.

Remove the mounting plate from the back of the

fixture.

ALLEN WRENCH

SET SCREW

MOUNTING

PLATE

Attach the mounting plate to the electrical box using

the two provided #8-32 screws .

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product may be dimmed with a low-voltage electronic

dimmer or a 0-10V dimmer depending on the wiring

configuration.

Suitable for wet locations.

OUTDOOR

PAGE 1
920OWVOTO6 Installation Instructions for Voto 6 Wall 700OWVOT_6_ OUTDOOR GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product may be dimmed with a low-voltage electronic dimmer or a 0-10V dimmer depending on the wiring configuration. Suitable for wet locations.
PAGE 2
1D 1C 35 4 6 5 10 4 Connect the backplate wire to a suitable ground in accordance with local electrical codes. SET SCREW ALLEN WRENCH 5 Connect the white driver wire to the neutral power line. 6 Connect the black driver wire to the hot power line. 8 Properly place all wires and wire nut connections into the fixture. 7 Use the gray and purple dimming wires for 0-10v dimming application (if not in use, make sure to cap these wires off).