Installation Sheet

4
5
6
Ensure that the mounting plate is level before
continuing.
Line up an anchor tip with the center of a mounting
plate hole, and push the anchor into the wall up to the
threads.
Screw the anchors in the rest of the way with a Phillips-
head screwdriver.
Repeat steps 5-6 for the other anchor.
7
8
9
Slide a #8 screw through a washer and screw it into an
anchor.
Repeat for the other anchor to secure the mounting
plate to the wall.
1C
3
5
ANCHOR
6
ANCHOR
1D
3
SCREW
WASHER
8
9
2
1E
3
12
11
10
Connect the backplate wire to a suitable ground in
accordance with local electrical codes.
Connect the white driver wire to the neutral power line.
Connect the black driver wire to the hot power line.
Use the gray and purple dimming wires for 0-10v
dimming application (if not in use, make sure to cap
these wires off).
10
Warning: The purple and gray wires are only
used for 0-10v dimming. For all other
applications, do not connect the gray and purple
wires.
Note for In-Line Fuse equipped fixtures: in the
case that the fixture is not operating correctly,
make sure to check the fuse.
13
11
12
13