Installation Sheet

1.0

Installation Instructions for

Zur Medium and Large Outdoor Wall

700OWZUR_

920OWZURML

CAUTION RISK OF FIRE-

This product must be installed in accordance with the applicable

installation code by a person familiar with the construction and

operation of the product and the hazards involved.

Use minimum 90°c supply conductors.

GENERAL PRODUCT INFORMATION:

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product is suitable for wet locations.

This product may be dimmed with a low-voltage electronic

dimmer or 0-10V dimmer.

This instruction shows a typical installation.

OUTDOOR

PAGE 1
920OWZURML Installation Instructions for Zur Medium and Large Outdoor Wall 700OWZUR_ 1.0 OUTDOOR GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is suitable for wet locations.
PAGE 2
Install the Fixture 1A ALLEN WRENCH & SET SCREW MOUNTING PLATE 14 9 7 SOCKET CAP SCREW W/ O-RING DRIVER 10 8 15 15 13 ANCHOR ANCHOR SCREW & WASHER 1 With the provided Allen wrench, remove the set screws and o-rings on both sides of the fixture base. 2 Remove the mounting plate from the fixture base 3 Install the mounting plate to the junction box with the two #8-32 screws provided. 4 Verify that the mounting plate is level before continuing.