Installation Guide

1
Installing the Prism Glass Shield
Place the louver or the glass lens (optional) into the Snap
Louver Lens Holder.
Place the MR16 lamp into the Snap Louver Lens Holder.
Press the tabs on both sides of the Snap Louver Lens
Holder against the MR16 lamp to keep it in the position.
MR16 LAMP
LOUVER OR
GLASS LENS
TAB
SNAP LOUVER
LENS HOLDER
If the Prism glass shield fits tight onto the fixture, then
carefully bend the grooved shade holder tabs in slightly
with the needlenose pliers. If it fits loose, then carefully
bend the grooved shade holder tabs out slightly with the
needlenose pliers.
GROOVED SHADE
HOLDER TAB
PRISM GLASS SHIELD
MR16 LAMP PIN
SOCKET HOLE
GROOVED SHADE
HOLDER
Use 50 Watt type MR16
Front Cover Halogen Lamp.
MAX
Place the Snap Louver Lens Holder assembly into the
Prism glass shield.
Line the lamp pins up with the fixture socket holes.
Insert the lamp pins into the socket holes; simultaneously
push the Prism glass shield onto the grooved shade
holder.
GENERAL PRODUCT INFORMATION:
This product is suitable for dry locations only.
Installation Instructions for
Prism Glass Shield
950PRISMS
1.0
ACCESSORIES
_00PRISM_S
1C
1
2
3
1
2
3
1B
1A
4
4
5
6
7
5
6
7
1D
3