Installation Guide

1.2
Installation Instructions for
Soda Accessory
700SDA_
1
920SODAAC
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
This product must be used with Tech Lighting systems only.
ACCESSORIES
If the Soda accessory fits tight onto the fixture, then
carefully bend the grooved shade holder tabs in slightly
with the needlenose pliers. If it fits loose, then carefully
bend the grooved shade holder tabs out slightly with
the needlenose pliers.
GROOVED SHADE
HOLDER TAB
Installing the Soda Accessory
Use MAX 50 Watt MR16 Front Cover Halogen
Lamp.
Place the louver or the glass lens (optional) into the
Snap Louver Lens Holder.
Place the MR16 lamp into the Snap Louver Lens Holder.
Press the tabs on both sides of the Snap Louver Lens
Holder against the MR16 lamp to keep it in the position.
MR16 LAMP
LOUVER OR
GLASS LENS
TAB
SNAP LOUVER
LENS HOLDER
GROOVED
SHADE HOLDER
SODA ACCESSORY
MR16 LAMP
Place the MR16 lamp into the Soda accessory.
METAL RING
1A
1B
1C
1D
1
2
3
4
2
3
4
5
6
6
Hold the lamp against the glass with the thumb and
push the lamp pins completely into the socket holes;
simultaneously push the Soda accessory metal ring onto
the grooved shade holder.
5
1