Installation Sheet

ManualsBrandsTech Lighting ManualsChandeliersSedona 4 Light 24-1/2" Wide LED Chandelier with Glass Globe Shades

Install the Mounting Plate

Separate the mounting plate from the canopy by

removing all four screws.

Secure the mounting plate to the electrical box with the

two #8-32 screws provided.

Remove the mounting plate from the canopy.

1.0

Installation Instructions for

Sedona Triple Chandelier

700SDNMPL3_

920SEDONACH3

CHANDELIER

MOUNTING

PLATE

#8-32 SCREW

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with the

construction and operation of the product and the

hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for damp locations.

Dimmable with LED compatible dimmer or triac dimmer.

MOUNTING PLATE

CANOPY

MOUNTING

PLATE SCREW

Summary of content (4 pages)

PAGE 1
920SEDONACH3 Installation Instructions for Sedona Triple Chandelier 700SDNMPL3_ 1.0 CHANDELIER GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. Dimmable with LED compatible dimmer or triac dimmer.
PAGE 2
Assemble the Fixture 1D 2A FIXTURE WIRES MOUNTING PLATE HANG STRAIGHT ALLEN WRENCH 4 4 4 4 4 SET SCREW 2 ANCHOR STEM 4 Line up an anchor with the center of a mounting plate hole and push the anchor in up to the threads. 5 Screw the anchor the rest of the way in with a screwdriver. 2 1E 3 MOUNTING PLATE FIXTURE 6 WASHER 6 6 6 NOTE: Complete the next steps for each section of the chandelier. #8 SCREW 1 Loosen the set screw on the hang straight using the provided Allen wrench.
PAGE 3
Install the Fixture Install the Pendants 3A 4A 1 END CAP 12" FIXTURE CORD 1 Leave 12" of the cord behind the canopy for power connections. Cut the excess cord. 2 Strip the end of the wires. 3B ELECTRICAL BOX 1 Slide the end cap over the fixture cord making sure the threading faces upward. 3 5 MOUNTING PLATE 4 4B STRAIN RELIEF 2 3 CANOPY SET SCREW 3 Connect the ground wire to a suitable ground in accordance with local electrical codes.
PAGE 4
Install the Lamps FEMALE CONNECTOR 4C 5A 6 TOP CAP 5 B SOCKET MALE CONNECTOR C AUTION: Exposed hot and neutral conductors may result in a short. Ensure no bare wire is exposed. 5 6 4D Push the neutral wire (white tracer) all the way into the side of the male connector that lines up with the white wire on the female connector. LAMP Push the hot wire all the way into the other side of the male connector.