Installation Sheet

7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
4
B
Install the Lamps
5A
Refer to fixture marking for lamp information.
CAUTION: To reduce the risk of a burn or electric
shock during re-lamping, disconnect the power to
the fixture.
Screw the lamps into the sockets.
1
LAMP
SOCKET
Push the neutral wire (white tracer) all the way into the
side of the male connector that lines up with the white
wire on the female connector.
Push the hot wire all the way into the other side of the
male connector.
5
6
Connect the male connector by pushing it into the
female connector until it locks in place.
Compress the ground wire connector and insert the
bare silver wire, then release the connector.
7
8
Gently insert all connections into the fixture arm.
Screw the end cap on to the fixture arm.
9
10
4C
4D
4E
MALE CONNECTOR
FEMALE CONNECTOR
FEMALE CONNECTOR
MALE CONNECTOR
FIXTURE ARM
END CAP
5
6
7
8
9
10
CAUTION: Exposed hot and neutral conductors may
result in a short. Ensure no bare wire is exposed.
Note: If glass hangs crooked, slightly loosen top cap
and adjust as needed once the fixture is hung, then
re-tighten.
TOP CAP