Installation Sheet

ManualsBrandsTech Lighting ManualsChandeliersSpur 45 Light 41" Wide LED Chandelier

Install the Mounting Plate

Secure the mounting plate to the electrical box with the

two washers and #8-32 screws provided.

Remove all the canopy screws using the provided Allen

Wrench.

Remove the mounting plate and driver from the canopy.

#8-32 SCREW

AND WASHER

MOUNTING PLATE

MOUNTING

PLATE

CANOPY

SCREW

1 1

CANOPY

DRIVER

3 3

ALLEN WRENCH

Two Person Installation Recommended

Installation Instructions for

920SPUR

Spur Chandelier

CHANDELIER

1.0

700TDSPR_

1.3

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with

the construction and operation of the product and the

hazards involved.

Use minimum 90°C supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product is suitable for damp locations.

This product may be dimmed with a low-voltage

electronic dimmer.

The fixture can be mounted to a ceiling with a 35 slope°

maximum.

This instruction shows a typical installation.

SAVE THESE INSTRUCTIONS!

Summary of content (4 pages)

PAGE 1
920SPUR Installation Instructions for Spur Chandelier 700TDSPR_ 1.0 1.3 CHANDELIER GENERAL PRODUCT INFORMATION: CAUTION - RISK OF FIRE These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is suitable for damp locations.
PAGE 2
Assemble the Fixture Install the Fixture 2A 3A FIXTURE WIRES 1 HALF BALL/ UPPER STEM ASSEMBLY DRIVER CANOPY 2 1 CANOPY 2 1 Connect the black driver wire to the black fixture wire with a wire nut. 2 Connect the red driver wire to the red fixture wire with a wire nut. 3 Neatly place the driver and wires inside the canopy. 3B 2 4 5 STEM 6 FIXTURE 3 1 Feed the half ball/upper stem assembly through the top of the canopy.
PAGE 3
Install the Glass 3C 4A ELECTRICAL BOX 8 8 CANOPY SCREW 8 ALLEN WRENCH CANOPY BASE GLASS 7 Neatly place all wires and wire nut connections inside the canopy. 8 Align the canopy holes with the mounting plate holes. Secure the canopy in place by tightening the canopy screws using the provided Allen Wrench. NOTE: The fixture can be mounted to a ceiling with a 42 degree slope maximum. 1 3 Install the glass by screwing it into the base. Do not over-tighten.
PAGE 4
7400 Linder Ave., Skokie, IL 60077 T 847.410.4400 | F 847.410.4500 www.techlighting.com ©2020 Tech Lighting, L.L.C. All rights reserved. The Tech Lighting logo is a registered trademark of Tech Lighting. Tech Lighting reserves the right to change specifications for product improvements without notification.