Installation Sheet

2




2A
1
2
3
Shorten the Cords (Optional)
NOTE: If shortening is necessary, ensure that the
cable identifiers are not removed during installation.
If no shortening is necessary, skip to section 3A.
-
Leave 6" behind for wire connections, cut off the excess
cord. NOTE: This fixture contains one dummy coaxial
cable.
From the end of the cord, strip the insulation and
braided conductor 4" using a sharp knife. Make sure
not to nick the center conductor wire.
Strip the end of the center conductor wire.












DUMMY COAXIAL CORD
CENTER
CONDUCTOR WIRE
COAXIAL CORD
+
Using the provided Allen wrench, loosen (Do Not
Remove) the set screw on each strain relief.
Place the fixture on a level surface.
Evenly pull the three coaxial cables through the canopy
until it reaches the length desired.
Install the inner bushings onto each coaxial cord and
slide them down and into the strain reliefs.
Ensure that the canopy is level and re-tighten the set
screws on the strain reliefs.
CANOPY
STRAIN
RELIEF
SET SCREW
COAXIAL
CABLE
ALLEN
WRENCH
1D
3
4
5
BUSHING
BUSHING
STRAIN
RELIEF
6
7














































































































































































































3
5
Line an anchor tip with the center of an anchor holes,
and push the anchors into the wall up to the threads.
Screw the anchors in the rest of the way with a Phillips-
head screwdriver.
Slide each #8 screw through a washer, and screw them
into the anchors to secure the mounting plate.
3
4
5
1C