Installation Sheet
3
Place all wires and wire nut connections properly inside
the canopy.
Align the canopy center hole with the crossbar center
hole.
Slide the canopy up against the ceiling and secure it in
place by tightening the decorative bolt.
DECORATIVE
BOLT
CANOPY
4A
2
3
1
Complete Installation
1
4
5
+
2
3
DRIVER
+
-
-
3A
Connect the fixture ground wire to a suitable ground in
accordance with local electrical codes.
Connect the red driver wire labeled “+” (positive) to the
fixture coaxial cable labeled “+”(positive) with a wire
nut.
Connect the black driver wire labeled “-” (negative) to
the fixture coaxial cable labeled “-” (negative)with a
wire nut.
Connect the black 120V input to the hot power line wire
with a wire nut.
Connect the white 120V input to the neutral power line
wire with a wire nut.
Connect the purple and grey wires for a 0-10V dimming
application.
2
3
4
5
1
6
Wire the Fixture
NOTE: The purple and gray wires are only used
for 0-10v dimming. For all other applications, do
not use the purple and grey wires.
6
Loosen (do not remove) the set screws on the canopy
strain relief on the side which needs adjusting.
Evenly and gently pull out the coaxial cable, in very small
increments, through the strain relief to adjust whichever
side to level the fixture.
Ensure that the fixture is level and re-tighten the set
screw on the strain relief.
STRAIN RELIEF
1
5A
2
2
Additional Leveling (optional)
NOTE: If necessary, minor leveling adjustments to
the fixture may be needed. It is recommended that
one person hold the fixture straight with the use of
a level while the other adjusts the coaxial cable.
CAUTION: Only pull out extra cable for leveling if
enough cord was left behind the canopy. Minimal
amounts of cord should be pulled out for fine
leveling.
3
1
CAUTION: Make sure to support the fixture if fine
leveling is necessary.