Canopy Installation Sheet

For power connection, leave at least 6" of the cord
exposed in the back of the canopy.
Cut off the excess cord with a sharp cutter.
From the end of the cord, strip the outer insulation 4"
using a sharp knife and needlenose pliers. Make sure
not to cut inner wires.
Strip 1/4" of insulation from the inner insulated wires.
(three inner insulated wires for standard SVT cord). The
bare inner wire is the ground wire (green insulated wire in
SVT cord).
4"
2
From back of the canopy tighten the strain relief to the
cord grip.
STRAIN RELIEF
CANOPY
Shorten the Pendant (cloth covered cord)
2B
NOTE: Refer to the instructions provided with the
pendant fixture to install the fixture shade (if needed)
before proceeding with these steps.
Feed end of the pendant cord through the strain relief
into the canopy.
Adjust the fixture height (from bottom of the fixture shade
to top of the canopy) by moving the cord up or down.
When desired height is achieved, tighten the strain relief
slot head screw.
CORD
SLOT HEAD SCREW
SKIP TO SECTION 3.
1A1C
1A
1D
1A
2A
1A
2B
7
8
1
9
10
2
3
4
7
8
1
9
4