Canopy Installation Sheet

Install the Fixture
FIXTURE WIRE
WITH WHITE
STRIP (WHITE IN
SVT CORD)
FIXTURE BARE WIRE
(GREEN IN SVT CORD)
FIXTURE WIRE
WITHOUT WHITE
STRIP (BLACK IN
SVT CORD)
Connect the fixture bare uninsulated wire (green in SVT
cord) to the ground in accordance with local electrical
codes.
Connect the fixture wire with the white strip (white in SVT
cord) to the 120 volt neutral power line wire with a wire
nut.
Connect the last fixture wire (black in SVT cord) to the
120 volt hot power line wire with a wire nut.
Place all wires properly into the electrical box.
Mount the canopy to the electrical box with two #8-32
screws provided.
#8-32 SCREW
For power connection, leave at least 6" of the cord
exposed in the back of the canopy.
Cut off the excess cord with a sharp cutter.
4"
From the end of the cord, cut away the cloth and strip the
outer insulation 4" using a sharp knife and needlenose
pliers. Make sure not to cut inner wires.
Strip 1/4" of insulation from the inner insulated wires.
(three inner insulated wires for standard SVT cord). The
bare inner wire is the ground wire (green insulated wire in
SVT cord).
3
1A
2C
1A
2D
1A
3A
1A
3B
5
6
7
8
1
2
3
4
5
5
6
5
6
7
4
5
5
1
2
3