Installation Sheet

ManualsBrandsTech Lighting ManualsLightingAudra Grande Single Light 7-3/8" Wide Line-Voltage LED Suspension Pendant with a Thick Glass Shade

1.1

Installation Instructions for

Audra

700 _TDADR

920TDAUDRA

P-LVENDANTS OW OLTAGE

Assemble the Pendant

GP I :ENERAL RODUCT NFORMATION

This product is suitable for indoor dry locations only.

This fixture is intended to be installed utilizing NEC

compliant junction boxes.

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with the

construction and operation of the product and the

hazards involved.

Use minimum 90°c supply conductors.

From back of the canopy tighten the strain relief to the

cord grip.

From front of the canopy remove the cap from cord

grip.

CAP

CORD GRIP

STRAIN RELIEF

CANOPY

Feed end of the pendant cord through the cap, cord

grip, and strain relief into the canopy.

Adjust the fixture height (from bottom of the fixture

shade to top of the canopy) by moving the cord up or

down.

When desired height is achieved, tighten the cap.

CORD

CAP

SLOT HEAD SCREW

Summary of content (4 pages)

PAGE 1
920TDAUDRA Installation Instructions for Audra 700TDADR_ 1.1 P ENDANTS -L OW V OLTAGE GENERAL PRODUCT INFORMATION: This product is suitable for indoor dry locations only. This fixture is intended to be installed utilizing NEC compliant junction boxes. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.
PAGE 2
Install the Fixture 1C 1 2A 7 4 6 3 DRIVER 2 2 6 For power connection, leave at least 6" of the cord exposed in the back of the canopy. 7 Cut off the excess cord with a sharp cutter. 1D NOTE: If the canopy mounting holes do not match up with electrical box, install the provided universal mounting plate before making wire connections. 1 Connect the fixture bare uninsulated wire to the ground in accordance with local electrical codes.
PAGE 3
Replacing the Lamp C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. 3C NOTE: lamp shield is for halogen lamping option only. 3A 1 SHADE 5 LAMP SHIELD 5 BI-PIN LAMP Push the lamp shield onto the spring clip. 2 LAMP SHIELD 3D 1 Slide the glass shade up to expose the socket. 2 Remove the lamp shield and the old lamp. 3B 6 BI-PIN LAMP 4 For incandescent versions, use MAX 35 Watt Bi-Pin Halogen Lamp.
PAGE 4
IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – Use this fixture indoors only. – Do not look directly at the lighted lamp. – Do not remain in light if skin feels warm. – Risk of fire: Use only the type of lamp and maximum wattage indicated in this instruction manual. – Never cover the halogen lamp with anything other than a Tech Lighting lamp shield and never place flammable material close to your fixture.