Installation Sheet

N
H
1A
Install the Fixture
CANOPY
MOUNTING
PLATE
#8-32
SCREW
DRIVER
2
1
Remove the mounting plate and driver from the canopy.
Secure the mounting plate to the junction box with the provided #8-32 screws. DANGER: If the junction box is not
rated for 75 lbs. or more, the mounting plate must be supported independently of the junction box.
Determine the desired height of the fixture using the provided stems and half ball/upper stem and assemble them by
screwing them together.
Slide the collar nut over the half ball/stem assembly.
Feed the fixture wires through the stem assembly, then screw the stem assembly to the top of the fixture.
Feed the fixture wires and half ball/stem assembly through the canopy, then seat the half ball into the mounting
plate.(.)Make sure to avoid pinching the wires
Connect the blue driver wire to the blue fixture wire with a wire nut.
Connect the red driver wire to the red fixture wire with a wire nut.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wires to the neutral power line wire with a wire nut.
Connect the black driver wires to the hot power line wire with a wire nut.
Neatly place the drivers, all wires, and wire nut connections inside the canopy, slide the canopy up to over the
mounting bracket and secure in place with the collar nut.
2
3
4
5
6
7
8
9
10
11
LAG
SCREW
N
H
FIXTURE
CANOPY
STEM ASSEMBLY
HALF BALL/
UPPER STEM
FIXTURE
3
5
7
3
4
COLLAR NUT
12
8
2