Installation Sheet

Installation Instructions for

920TDHUTCH

Hutch Pendant

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Mounting Plate

Remove the canopy screws using the provided Allen

Wrench.

Remove the mounting plate from the canopy.

Two Person Installation Recommended

PENDANTS

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product is suitable for damp locations.

This product can be dimmed with a standard electronic

dimmer.

This instruction shows a typical installation.

CANOPY

SCREW

ALLEN

WRENCH

CANOPY

Secure the mounting plate to the electrical box with the

two washers and #8-32 screws provided.

#8-32 SCREW

AND WASHER

MOUNTING PLATE

3 3

MOUNTING

PLATE

1.1

700 HTCP_TD

PAGE 1
920TDHUTCH Installation Instructions for Hutch Pendant 700TDHTCP_ 1.1 PENDANTS GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product can be dimmed with a standard electronic dimmer. This instruction shows a typical installation.
PAGE 2
Assemble the Fixture Install the Fixture 2A 3A FIXTURE WIRES HANG STRAIGHT 3 6" 1 Leave 6" of the wire behind the canopy for power connections. Cut the excess wire. 2 Strip the end of the wires. 1 STEM 3B 1 3 2 4 FIXTURE 5 6 1 2 3 Determine desired length of fixture using the provided stems and assemble them by screwing them together. Feed the fixture wires through the stem assembly and screw it to the fixture.
PAGE 3
C ELECTRICAL BOX CANOPY SCREW ALLEN WRENCH 7 Neatly place all wires and wire nut connections inside the canopy. 8 Align the canopy holes with the mounting plate holes. Secure the canopy in place by tightening the canopy screws using the provided Allen Wrench.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.