Installation Sheet

Place all wires, wire nut connections, driver properly
inside the junction box.
Lift the canopy up against the ceiling and secure it in
place by tightening the screws.
9
2D
2
CORD
SCREW
10
Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
From the end of the cord, strip the insulation 4" using
a sharp knife. .Make sure not to nick the inner wires
Strip the end of the wires.
2
2B
4"
3
4
Connect the negative (black) driver wire to the
pendant wire with white tracer with a wire nut.
Connect the positive (red) driver wire to the
remaining pendant wire with a wire nut.
Connect the fixture and the crossbar ground wire to a
suitable ground in accordance with local electrical
codes.
Connect the white driver wire to the neutral power
line wire with a wire nut.
Connect the black driver wire to the hot power line
wire with a wire nut.
5
2C
6
7
11
DRIVER
5
6
8
9
8
9