Installation Guide

Installation Instructions for

700T_LEXP_-CF

920TDLEXPCF

PENDANTS

GENERAL PRODUCT INFORMATION:

This product is suitable for damp locations.

Lexington Pendant (Compact Fluorescent)

Install the Lamps

Use Watt GX24Q-3 Base

Triple Tube Compact Fluorescent Lamp

with each socket.

GX24Q-3 Base Triple Tube

Compact Fluorescent Lamps are

recommended.

MAX 32

Watt

Push the lamp pins all the way into the socket holes.

SOCKET

LAMP

2.2

Install the Shade

CABLE

CAP

SHADE

Unscrew the cap from the top of the socket assembly

and slide the cap nut off the cable.

Feed the cable through the center of the shade support

until it rests on the end of the socket assembly.

Feed the cable through the center of the cap and screw

the cap back onto the socket assembly.

Attach the shade to the socket assembly before

installing the canopy.

PAGE 1
Installation Instructions for 920TDLEXPCF Lexington Pendant (Compact Fluorescent) 700T_LEXP_-CF PENDANTS GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. Attach the shade to the socket assembly before installing the canopy. Install the Shade Install the Lamps 1A 2A CABLE CAP SHADE 1 SOCKET 1 Unscrew the cap from the top of the socket assembly and slide the cap nut off the cable.
PAGE 2
Install the Glass Disk 3A 3B FABRIC SHADE SHADE PEG BUSHING 2 JAM NUT NIPPLE 1 BOTTOM OF THE FABRIC SHADE NIPPLE 3 CAP 1 Loosen the knurled nut and adjust the nipple height so the back of the cap is level with bottom of the shade. 2 Tighten the jam nut firmly against the bushing. CAP GLASS DISK 3 Remove the cap. 4 Place the glass disk onto the nipple and secure it against the shade pegs with the cap. NOTE: Do not over tighten the cap.