Installation Guide

ManualsBrandsTech Lighting ManualsWall SconcesTech Lighting Larkspur Cone Shaped Fused Surf White Glass Wall Sconce

1.8

Installation Instructions for

700TDLRKS_

920TDLRKS

SCONCES

GENERAL PRODUCT INFORMATION:

This product can mount to either a 4" square electrical box

with round plaster ring or an octagon electrical box.

This product is suitable for damp locations.

This product can be dimmed with a standard incandescent

dimmer.

t h o u s a n d

d e g r e e s

Larkspur Sconce

C AUTION — RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWER TO THE

ELECTRICAL BOX OFF.

Mount the Sconce

Ground the fixture to the electrical box in accordance

with local electrical codes.

Connect the white fixture wire to the neutral 120 volt

power line wire with a wire nut.

Connect the black fixture wire to the hot 120 volt

power line wire with a wire nut.

Summary of content (4 pages)

PAGE 1
920TDLRKS Installation Instructions for Larkspur Sconce 700TDLRKS_ 2 dt he og u r s ea en ds 1.8 TM SCONCES GENERAL PRODUCT INFORMATION: This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box. This product is suitable for damp locations. This product can be dimmed with a standard incandescent dimmer. Mount the Sconce 1A C AUTION — RISK OF FIRE This product requires installation by a qualified electrician.
PAGE 2
1C 1B 7 7 MARKED POINT 4 #8-32 SCREW 6 6 ELECTRICAL BOX HOLE MOUNTING PLATE 4 Properly place all wires and wire nut connections into the electrical box. 5 Line up two mounting plate slots with the two electrical box holes. 6 MOUNTING PLATE HOLE 7 Mark three points onto the wall through the mounting plate holes. 7 1D 8 ANCHOR Level the mounting plate vertically and secure it to the electrical box with the two #8-32 screws.
PAGE 3
Install the Lamp & Glass Shade 1E 10 2A 10 #8 SCREW SOCKET 1 WASHER ANCHOR LAMP 10 Secure the mounting plate to the anchors with the #8 screws and washers. C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture by turning the wall switch off. Use MAX 120 Volt, 75 Watt Type T8 Medium Base Lamp. 1 3 Screw the lamp completely into the socket.
PAGE 4
2B 2D CAGE NUT 2 3 3 5 3 5 GLASS SHADE HOLE 2 Place the glass shade over the mounting plate against the wall. 3 Slide the cage nuts aligning their holes with the glass shade holes. 5 Firmly push the glass against the wall and finish tightening the ball screws. 2C 4 4 BALL SCREW SAVE THESE INSTRUCTIONS! 2 GLASS SHADE dt he og u r s ea en ds TM 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.2thousanddegrees.com © 2008 Tech Lighting, L.L.C. All rights reserved.