Installation Sheet

ManualsBrandsTech Lighting ManualsLightingManette 5" Wide LED Mini Pendant with Transparent Smoke Glass Shades

Installation Instructions for

700TDMANGP_

920TDMANGD

PENDANTS

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

This product can mount to either a 4" square electrical box

with round plaster ring or an octagon electrical box.

This product can be dimmed with a low-voltage electronic

dimmer.

Screw the (shorter) upper shade firmly into the shade

base.

1.1

Manette Grande Pendant

Assemble the Fixture

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

UPPER SHADE

SHADE BASE

LOWER SHADE

SHADE BASE

Rotate the fixture upside down, place the diffuser into

the shade base, and completely screw the (longer) lower

shade into the base.

DIFFUSER

Summary of content (4 pages)

PAGE 1
920TDMANGD Installation Instructions for Manette Grande Pendant 700TDMANGP_ 1.1 PENDANTS GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box. This product can be dimmed with a low-voltage electronic dimmer.
PAGE 2
Shorten the Pendant MOUNTING PLATE 2A 2C 10 STRAIN RELIEF 2 CANOPY SCREW 11 SLOT HEAD SCREW MARKED POINT 8 1 1 CANOPY CANOPY CORD GRIP CORD GRIP 3 1 Remove the canopy screws. 2 Remove the backplate from the canopy. 3 Remove the cap from the cord grip. CAP 8 Loosen the cap and feed the cord through the strain relief. Place the strain relief right above the marked point and tighten the slot head screw. 9 Slide the canopy up against the strain relief and tighten the cap to cord grip.
PAGE 3
Install the Pendant 3A 3C 8 8 #8-32 SCREW CANOPY SCREW MOUNTING PLATE 1 Secure the mounting plate to the electrical box with the two #8-32 screws provided. 3B 4 4 5 6 3 2 DRIVER 2 Connect the blue driver wire to the insulated pendant wire with the white tracer. 3 Connect the red driver wire to the other insulated pendant wire. 4 Connect the fixture to a suitable ground in accordance with local electrical codes. 5 Connect the black driver wire to the hot power line wire with a wire nut.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2014 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.