Installation Sheet

Remove the canopy screws.

Remove the backplate from the canopy.

Remove the cap from the cord grip.

CORD GRIP

CAP

CANOPY SCREW

CANOPY

MOUNTING PLATE

Shorten the Pendant

CORD GRIP

CAP

DOME

COVER

Feed end of the pendant cord through the cap, and cord

grip into the canopy.

Adjust the fixture height (from bottom of the fixture shade

to top of the canopy) by moving the cord up or down.

When desired height is achieved, slightly tighten the cap.

From inside mark the cord right behind the cord grip for

the strain relief location.

MARKED POINT

CORD GRIP

CAP

CANOPY

MARKED POINT

SLOT HEAD SCREW

Loosen the cap and feed the cord through the strain

relief. Place the strain relief right above the marked point

and tighten the slot head screw.

Slide the canopy up against the strain relief and tighten

the cap to cord grip.

For power connection, leave at least 6" of the cord

exposed in the back of the dome canopy.

Cut off the excess cord with a sharp cutter.

STRAIN RELIEF

From the end of the cord, strip the outer insulation 4"

using a sharp knife and needlenose pliers. Make sure

not to cut inner wires.

Strip 1/4" of insulation from the inner insulated wires.

(three inner insulated wires for standard SVT cord). The

bare inner wire is the ground wire (green insulated wire in

SVT cord).

1 1