Manualshelf

Canopy Installation

ManualsBrandsTech Lighting ManualsLightingMina 3 Light 10-3/32" Wide LED Multi Light Pendant with a Clear Outer and Inner Etched Glass Spheres and Warm Color Dimming
1234
2
Adjust each fixtures’ height (from bottom of the fixture
shade to top of the canopy) by pulling the fixture cords
through the strain relief.
When the desired look is achieved, tighten the set screw
on each strain relief.
4"
Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
From the end of the cord, strip the insulation 4" using a
sharp knife. .Make sure not to nick the inner wires
Strip the end of the wires.
Repeat for all the cords.
STRAIN RELIEF
CORD
3
4
SET SCREW
Ground the fixture wires with the green tracer and the
mounting plate to a suitable ground in accordance with
local electrical codes.
Connect the to thefixture wires with the white tracer
neutral power line wire.
Connect the remaining fixture wires to the hot power
line wire.
1A2B
3
1A2C
5
6
4
8
7
9
10
11
1A2D
9
9
10
11