Installation Sheet

Installation Instructions for

Matan Pendant

PENDANTS - LINE VOLTAGE

1.0

700 _TDMTN

920TDMATAN

Install the Lamp

Install the Glass

SOCKET

CAUTION: To reduce the risk of a burn or electric

shock during relamping, disconnect the power to

the fixture.

Screw the lamp into the socket.

Refer to fixture marking for lamp information

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for damp locations.

This product can be dimmed with a LED or TRIAC dimmer. Consult

lamp manufacturer for additional information.

This instruction shows a typical installation.

GLASS SHADE

MOUNTING ROD

LAMP

Place the hardware inside the glass shade and install the

three mounting rods by screwing them in completely.

PAGE 1
920TDMATAN Installation Instructions for Matan Pendant 700TDMTN_ 1.0 PENDANTS - LINE VOLTAGE GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product can be dimmed with a LED or TRIAC dimmer. Consult lamp manufacturer for additional information. This instruction shows a typical installation.
PAGE 2
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.