Installation Guide

Installation Instructions for

700T_MULP_-CF

920TDMULPCF

PENDANTS

GENERAL PRODUCT INFORMATION:

This product is suitable for damp locations.

Mulberry Pendant (Compact Fluorescent)

Install the Lamps

1.5

SOCKET

LAMP

Use Volt, Watt Type GU24

Base Self Ballasted Spiral Compact

Fluorescent Lamps.

MAX 18120

Push the lamp pins into the large portion of the socket

slots and rotate it clockwise to lock it in place securely.

Attach the shade to the socket assembly before

installing the canopy.

Install the Shade

Unscrew the cap from the top of the socket assembly

and slide the cap nut off the cable.

Feed the cable through the center of the shade support

until it rests on the end of the socket assembly.

Feed the cable through the center of the cap and screw

the cap back onto the socket assembly.

CABLE

CAP

SHADE

SOCKET

ASSEMBLY

PAGE 1
Installation Instructions for 920TDMULPCF Mulberry Pendant (Compact Fluorescent) 700T_MULP_-CF 1.5 PENDANTS GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. Attach the shade to the socket assembly before installing the canopy. Install the Shade Install the Lamps 1A 2A CABLE LAMP CAP SHADE SOCKET ASSEMBLY 1 SOCKET 1 Unscrew the cap from the top of the socket assembly and slide the cap nut off the cable.
PAGE 2
Install the Glass Disk 3A 3B SHADE PEG BUSHING NIPPLE NIPPLE JAM NUT BOTTOM OF THE FABRIC SHADE CAP GLASS DISK CAP 1 Loosen the knurled nut and adjust the nipple height so the back of the cap is level with bottom of the shade. 2 Tighten the jam nut firmly against the bushing. 3 3 Remove the cap. 4 Place the glass disk onto the nipple and secure it against the shade pegs with the cap. NOTE: Do not over tighten the cap. Overtightening may break the glass and result in injury.