Installation Guide

2
SAVE THESE INSTRUCTIONS!
3B3A
Install the Glass Disk
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
CAP
GLASS DISK
CAP
3
BOTTOM OF THE
FABRIC SHADE
JAM NUT
NIPPLE
BUSHING
Loosen the knurled nut and adjust the nipple height so
the back of the cap is level with bottom of the shade.
Tighten the jam nut firmly against the bushing.
1
2
Remove the cap.
Place the glass disk onto the nipple and secure it against
the shade pegs with the cap.
3
4
NOTE: Do not over tighten the cap. Overtightening
may break the glass and result in injury.
NIPPLE
SHADE
PEG
Statement of Warranty
Tech Lighting warrants all products manufactured to
be free from defects in material and workmanship
under normal use for 3 years after the date of
original purchase. This warranty only applies when
components, including power supplies, have been
provided by Tech Lighting.
Upon confirmation of a defect or failure, at our
discretion we will repair or replace the item or will
refund your purchase price if repair or replacement is
not possible or practical. Our warranty covers only
the product itself; we will assume no liability for
labor costs, installation costs, or other losses.