Installation Guide

1.4

Installation Instructions for

700T_MULP_

920TDMULP

PENDANTS

GENERAL PRODUCT INFORMATION:

This product is suitable for damp locations.

This product can be dimmed with a standard incandescent

dimmer.

Mulberry Pendant

Install the Lamps

Screw the lamps into the sockets.

Use Volt, Watt A19

(medium) base lamp with each socket.

MAX 120 75

SOCKET

LAMP

Attach the shade to the socket assembly before

installing the canopy.

Install the Shade

Unscrew the cap from the top of the socket assembly

and slide the cap nut off the cable.

Feed the cable through the center of the shade support

until it rests on the end of the socket assembly.

Feed the cable through the center of the cap and screw

the cap back onto the socket assembly.

PAGE 1
920TDMULP Installation Instructions for Mulberry Pendant 700T_MULP_ PENDANTS GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product can be dimmed with a standard incandescent dimmer. Attach the shade to the socket assembly before installing the canopy. Install the Shade Install the Lamps 1A 2A LAMP 1 SOCKET 1 Unscrew the cap from the top of the socket assembly and slide the cap nut off the cable.
PAGE 2
Install the Glass Disk 3B 3A SHADE PEG BUSHING NIPPLE NIPPLE JAM NUT BOTTOM OF THE FABRIC SHADE CAP GLASS DISK CAP 1 Loosen the knurled nut and adjust the nipple height so the back of the cap is level with bottom of the shade. 2 Tighten the jam nut firmly against the bushing. 3 3 Remove the cap. 4 Place the glass disk onto the nipple and secure it against the shade pegs with the cap. NOTE: Do not over tighten the cap. Overtightening may break the glass and result in injury.