Installation Sheet

2
Assemble the Fixture
4
5
6
PIVOT
STEM
FIXTURE
Determine desired length of fixture using the provided
stems and assemble them by screwing them together.
CAUTION: Do not over-tighten the stems, as it may
cause the stems to misalign.
Feed the fixture wires through the stem assembly and
screw it to the fixture.
Feed the fixture wires through the pivot and screw it
onto the stem assembly.
Adjust the pivot as necessary.
Note: pivot accommodates up to a 45 degree ceiling.
5
4
4
6
FIXTURE WIRES
2B
7
4
5
6
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Connect the black fixture wire to the hot power line wire
with a wire nut.
Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
From the end of the cord, strip the insulation .5" using a
sharp knife. .Make sure not to nick the inner wires
Strip the end of the wires.
6"
3A
1
2
3
3B
5
6
4
Install the Fixture