Installation Sheet

1A
Install the Fixture
2
1
Remove all the Allen screws around the canopy using the provided Allen Wrench and remove the mounting plate.
Secure the mounting plate to the electrical box with the #8-32 screws.
Determine the desired height of the fixture, loosen the set screw on the strain relief and feed the cable into the strain relief until
the desired height is achieved. Re-tighen the set screw on the strain relief to secure the cable in place. Repeat for the remaining
cables.
Connect the blue driver wire to the blue fixture wire with a wire nut.
Connect the red driver wire to the red fixture wire with a wire nut.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire(s) to the neutral power line wire with a wire nut.
Connect the black driver wire(s) to the hot power line wire with a wire nut.
Neatly place all cables, wires, and wire nut connections inside the canopy, align the canopy holes with the mounting plate holes,
and secure the canopy in place by tightening the Allen screws using the provided Allen Wrench.
NOTE: If minor adjustments to the fixture's leveling is necessary, it is recommended that one person hold the fixture straight with
the use of a level while the other adjusts the cables following the steps below.
Fine Leveling (Optional): Loosen (do not remove) the set screws on the necessary strain relief and gently pull or push the cable in
very small increments through the strain relief to adjust the height of the fixture. Re-tighten the set screw on the strain relief using
the provided Allen Wrench.
2
3
4
5
6
7
8
CABLE
CANOPY
MOUNTING PLATE
CANOPY SCREW
SET SCREW
ALLEN WRENCH
CABLE
DRIVER
9
10
4
5
6
7
8
1
10