Installation Sheet

SET SCREW

1.1

Installation Instructions for

Bowman 4 & 6 Wall

700 _WSBOW

920WSBOWMD

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product is suitable for wet locations.

This product may be dimmed with a low-voltage electronic

dimmer.

WCALL OLLECTION

Install the Fixture

With the Allen wrench provided, back out (do not fully

remove) the set screw at the base of the fixture.

Remove the mounting plate from the back of the

fixture.

ALLEN WRENCH

Attach the mounting plate to the electrical box using

the two provided #8-32 screws .

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

MOUNTING

PLATE

PAGE 1
920WSBOWMD Installation Instructions for Bowman 4 & 6 Wall 700WSBOW_ W ALL C OLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for wet locations. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
1C 1E 4 5 6 DRIVER 4 Connect the ground wire to a suitable ground in accordance with local electrical codes. 5 Connect the white driver wire to the neutral power line with a wire nut. 6 Connect the black driver wire to the hot power line with a wire nut. 7 Place the driver and all wire nut connections neatly into the junction box. 11 For wet locations, caulk around the base with waterproof construction sealant.