Installation Guide

ManualsBrandsTech Lighting ManualsWall SconcesTech Lighting Cosmo Rectilinear White Acrylic Fluorescent Wall Sconce

1.7

Installation Instructions for

Cosmo

700WSCOS_

920WSCOSM

GENERAL PRODUCT INFORMATION:

This product can mount to either a 4" square electrical box

with round plaster ring or an octagon electrical box.

This product is suitable for damp locations.

This product can be dimmed with a standard incandescent

dimmer.

WALL COLLECTION

C AUTION — RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWER TO THE

ELECTRICAL BOX OFF.

Install the Backplate

Remove the two #8-32 screws on the backplate with a

Phillips head screwdriver.

Remove the backplate from the sconce base.

#8-32 SCREW

BACKPLATE

SCONCE BASE

BACKPLATE

LONG #8-32 SCREW

ELECTRICAL BOX

Mount the backplate to the electrical box with two long

#8-32 screws.

Summary of content (4 pages)

PAGE 1
920WSCOSM Installation Instructions for Cosmo 700WSCOS_ 1.7 WALL COLLECTION GENERAL PRODUCT INFORMATION: This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box. C AUTION — RISK OF FIRE This product is suitable for damp locations. This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF.
PAGE 2
Connect the Power 2B 2A 7 3 #8-32 SCREW 2 5 6 4 7 1 Turn the power to the electrical box off. 6 2 Make sure that the backplate is grounded in accordance with local electrical codes. Place the sconce base onto the backplate and align the holes. 7 Replace and tighten the #8-32 screws. 3 Connect the black fixture wires to the hot power line wire with a wire nut. 4 Connect the white fixture wires to the neutral power line wire with a wire nut. 5 Properly place all wires into the backplate.
PAGE 3
Install the Lamps and Glass Shade 3A 3B GLASS SHADE EDGES SOCKET 1 LAMP LAMP 1 SOCKET 2 NOTE: Use only your fingers and a soft cloth to replace the lamp. BRACKET CHANNEL CAUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture by turning the wall switch off. Use MAX 120 Volt, 40 Watt Type E11 Base Mini Candelabra Halogen Lamp. 1 Screw the lamps into the sockets.
PAGE 4
IMPORTANT SAFETY INSTRUCTIONS Halogen Lamp General Information To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – A new halogen lamp may smoke slightly when it is used for the first time. This is perfectly normal; the protective coating is simply being vaporized. – Use this fixture indoors only. – Do not look directly at the lighted lamp. Two Tips For Prolonging Halogen Lamp Life – Do not remain in light if skin feels warm.