Installation Guide
1.2
Installation Instructions for
Essex
700WSESX_
1
920WSESSEX
GENERAL PRODUCT INFORMATION:
This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
This product is suitable for indoor damp locations.
WALL COLLECTION
C AUTION — RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and DISCONNECT POWER TO THE
ELECTRICAL BOX.
Mount the Sconce
1A
2
3
1
1B
#8-32 SCREW
MOUNTING PLATE
Properly place all wires and wire nut connections into
the electrical box.
Line up two mounting plate slots with the two electrical
box holes.
Level the mounting plate vertically and secure it to the
electrical box with the two #8-32 screws.
ELECTRICAL
BOX HOLE
5
6
7
5
6
7
7
Loosen the Allen-head screw and remove the upper arm.
Connect the braided copper wire to a suitable ground in
accordance with local electrical codes.
Connect the white fixture wire to the neutral 120 volt
power line wire with a wire nut.
Connect the black fixture wire to the hot 120 volt power
line wire with a wire nut.
1
2
3
4
1