Installation Sheet

ManualsBrandsTech Lighting ManualsIndoor Wall LightsGambit Single Light 9" High LED Wall Sconce with a Glass Globe Shade

1.0

Installation Instructions for

Gambit Wall & Gambit Triple Wall

700WSGMBSC_,700WSGMBTC_

920WSGAMBIT

WCALL OLLECTION

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product can be dimmed with a LED or TRIAC dimmer.

Consult lamp manufacturer for additional information.

Level the mounting plate and secure it to the electrical

box with the two #8-32 screws provided.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Fixture

ALLEN

WRENCH

SET SCREW

MOUNTING

PLATE

With the Allen wrench provided, back out (do not fully

remove) the set screw at the base of the fixture.

Remove the mounting plate from the back of the

fixture.

Summary of content (4 pages)

PAGE 1
920WSGAMBIT Installation Instructions for Gambit Wall & Gambit Triple Wall 700WSGMBSC_,700WSGMBTC_ 1.0 W ALL C OLLECTION GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product can be dimmed with a LED or TRIAC dimmer. Consult lamp manufacturer for additional information.
PAGE 2
1C 1E ANCHOR 11 10 9 ANCHOR 4 11 7 Verify that the mounting plate is level before continuing. 5 Line an anchor tip with the center of an anchor hole, and push the anchor into the wall up to the threads. 6 Screw the anchor in the rest of the way with a Phillipshead screwdriver. 7 Repeat for the other anchor hole. 1D ANCHOR WASHER SCREW ANCHOR 8 8 11 Slide a #8 screw through a washer, and screw it into an anchor to secure the fixture base to the wall. Repeat for the other anchor.
PAGE 3
Install the Lamp and Diffuser 1F 2A 13 LAMP SOCKET 1 C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. 12 Properly place all wires and wire nut connections into the electrical box. Refer to fixture marking for lamp information 13 Hook the top of the fixture to the bottom of the mounting plate and swing the top of the fixture toward the plate until it is flush with the wall.
PAGE 4
2B GLASS BASE SAVE THESE INSTRUCTIONS! CAUTION: DO NOT OVER TIGHTEN the glass. This may break the glass resulting in injury. 2 Gently screw the glass onto it’s base. 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.