Installation Guide

ManualsBrandsTech Lighting ManualsWall SconcesTech Lighting Hudson Cylindrical Glass Wall Washer Sconce

GENERAL PRODUCT INFORMATION:

This product can mount to either a 4" square electrical box

with round plaster ring or an octagon electrical box.

This product can be mounted vertically or horizontally.

This product is suitable for indoor damp locations.

This product can be dimmed with a standard incandescent

dimmer.

This instruction shows a typical installation.

Installation Instructions for

920WSHUDSON

Hudson Wall

700WSHUD2_

1.0

Install the Fixture

CAUTION - RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWER TO THE

ELECTRICAL BOX OFF.

With the provided Allen wrench, unscrew (Do Not

Remove) the set screw on the bottom of the fixture

ALLEN WRENCH

SET SCREW

FIXTURE BASE

MOUNTING PLATE

Pull out the mounting plate from the fixture base.

WALL COLLECTION

Summary of content (4 pages)

PAGE 1
Installation Instructions for 920WSHUDSON Hudson Wall 700WSHUD2_ WALL COLLECTION GENERAL PRODUCT INFORMATION: This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box. This product can be mounted vertically or horizontally. This product is suitable for indoor damp locations. This product can be dimmed with a standard incandescent dimmer. This instruction shows a typical installation.
PAGE 2
1 E 1C TOP OF THE FIXTURE BASE TAB MOUNTING PLATE TOP TAB 4 3 #8-32 SCREW 4 MOUNTING PLATE 5 9 3 TAB 3 Make sure the two tabs on the mounting plate are positioned at the top and bottom of the plate for vertical mounting; at the left and right for horizontal mounting. 4 Line up two mounting plate slots with the two electrical box holes. 5 Level the mounting plate and secure it to the electrical box with the two #8-32 screws provided.
PAGE 3
1H 1G LAMP GLASS SHADE 15 RETAINING RING SOCKET SOCKET 12 FIXTURE HOUSING RETAINING RING 13 RETAINING RING TOOL Use MAX 120 Volt, 75 Watt A19 Medium Base Lamp, For Each Socket. 15 12 Position the glass shade against the fixture housing. 13 Secure the glass shade by screwing the retaining ring onto the lamp socket using the retaining ring tool. 14 Repeat for the other side. NOTE: Use only the retaining ring tool to tighten or loosen the retaining ring.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.