Installation Sheet

1.0

Installation Instructions for

Kisdon (LED)

700WSKISWW_LED_

920WSKISDND

GP I :ENERAL RODUCT NFORMATION

This fixture is intended to be installed utilizing NEC

compliant junction boxes.

Suitable for damp locations.

This fixture may be dimmed with a low-voltage electronic

dimmer.

WCALL OLLECTION

Install the Fixture

Back out the set screw at the bottom of the fixture and

remove the backplate.

Screw the backplate to the electrical box.

SAVE THESE INSTRUCTIONS!

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

PAGE 1
920WSKISDND Installation Instructions for Kisdon (LED) 700WSKISWW_LED_ W ALL C OLLECTION GENERAL PRODUCT INFORMATION: This fixture is intended to be installed utilizing NEC compliant junction boxes. Suitable for damp locations. This fixture may be dimmed with a low-voltage electronic dimmer. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
Install the Shade 1C 2A 1 3 5 4 2 3 Connect the backplate wire to a suitable ground in accordance with local electrical codes. 4 Connect the white wire to the neutral power line. 5 Connect the black wire to the hot power line. 1 Line up the slot in the back side of the glass shade with the guide channel on the fixture. 2 Slide the glass shade all the way to the stop. If installing the fixture so the glass points downward, hold the glass in place with one hand until step 6 is complete.