Installation Sheet

2
2
1
With the provided Allen wrench, remove the set screw on the bottom of the fixture base.
Remove the mounting plate from the fixture base
Install the mounting plate to the junction box with the two #8-32 screws provided.
Connect the black/blue driver wire to the black fixture wire with a wire nut.
Connect the red driver wire to the red fixture wire with a wire nut.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line with a wire nut.
Connect the black driver wire to the hot power line with a wire nut.
For 277V Only: If using 0-10V dimming, connect the purple and gray wires to a compatible dimmer. If not using 0-10V dimming,
cap off the purple and gray wires.
Properly place the driver, all wires, and wire nut connections into the junction box, mount the fixture base onto the mounting plate, and
secure it in place by reinstalling the set screw using the provided Allen wrench.
Install the glass by carefully screwing it into the base. Repeat for remaining glass.Do not over tighten.
Note: For the Spur, install the glass so that the glass is facing forward once installed
1A
Install the Fixture
4
3
6
5
7
9
8
10
ALLEN WRENCH
& SET SCREW
DRIVER
MOUNTING PLATE
JUNCTION BOX
#8-32 SCREW
GLASS
BASE
11
11
THIS SIDE MUST
FACE FORWARD
11
NOTE: Installation for the Mara shown.
Installation is the same for the Spur.