Installation Sheet

1.0

Installation Instructions for

Mura Wall (LED)

700WSMUR_-LED

920WSMURA

GP I :ENERAL RODUCT NFORMATION

Mount to either a 4" square electrical box with

round plaster ring or an octagonal electrical box.

Suitable for damp locations.

WCALL OLLECTION

CAUTION—RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN OFF POWER TO THE

ELECTRICAL BOX.

Install the Mounting Plate

With the Allen wrench provided, back out (do not fully

remove) the set screw at the base of the fixture.

Remove the mounting plate from the back of the

fixture.

ALLEN

WRENCH

SET SCREW

MOUNTING

PLATE

3 3

Secure the mounting plate to the electrical box with the

provided #8-32 screws .

#8-32 SCREW

MOUNTING

PLATE

Note: Assistance will be need to mount this fixture.

PAGE 1
920WSMURA Installation Instructions for Mura Wall (LED) 700WSMUR_-LED 1.0 W ALL C OLLECTION GENERAL PRODUCT INFORMATION: Mount to either a 4" square electrical box with round plaster ring or an octagonal electrical box. Suitable for damp locations. C AUTION — RISK OF FIRE This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN OFF POWER TO THE ELECTRICAL BOX. Note : Assistance will be need to mount this fixture.
PAGE 2
Install the Diffuser Install the Fixture 2A 3A DRIVER 2 DIFFUSER 1 THUMB SCREW DIFFUSER BRACKET 3 1 Connect the fixture to a suitable ground in accordance with local electrical codes. 1 Line up the diffuser holes with the diffuser bracket holes (diffuser’s textured side out). 2 Connect the white fixture wire to the neutral power line wire with a wire nut. 2 Secure the diffuser in place with the two provided thumb screws. DO NOT OVER TIGHTEN.