Installation Sheet

1.1

Installation Instructions for

Orbel Wall

700WSOBL

920WSORBEL

WALL

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product can be dimmed with most ELV or TRIAC dimmers.

This product may be mounted up or down.

This instruction shows a typical installation.

SAVE THESE INSTRUCTIONS!

7400 Linder Ave, Skokie, 60077IL

847.410.4400

www.techlighting.com

a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right

to change specifications for product improvements without notification.

A Generation Brands Company

PAGE 1
920WSORBEL Installation Instructions for Orbel Wall 700WSOBL 1.1 CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. WALL GENERAL PRODUCT INFORMATION: Use minimum 90°c supply conductors. This product is suitable for damp locations. These fixtures are intended to be installed utilizing NEC compliant junction boxes.
PAGE 2
Install the Fixture 1A MOUNTING PLATE JUNCTION BOX #8-32 SCREW 5 SHADE SOCKET 3 4 3 6 SLOT ALLEN WRENCH & SCREW 9 1 With the provided Allen wrench, remove the Allen screws both sides of the fixture base. 2 Remove the mounting plate from the fixture base 3 Install the mounting plate to the junction box with the two #8-32 screws provided. 4 Connect the fixture to a suitable ground in accordance with local electrical codes.