Installation Sheet

2
2
1
With the provided Allen wrench, remove the Allen screws both sides of the fixture base.
Remove the mounting plate from the fixture base
Install the mounting plate to the junction box with the two #8-32 screws provided.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line with a wire nut.
Connect the black fixture wire to the hot power line with a wire nut.
Properly place the driver, all wires, and wire nut connections into the junction box, mount the fixture base onto the mounting plate, and
secure it in place by reinstalling the Allen screws using the provided Allen wrench.
Install the lamp by pushing it into the socket. Refer to the label on the socket for Max Wattage information.
Screw the shade onto the threads on the socket. Make sure the shade is installed correctly before releasing. Do not over tighten.
Optional: This fixture features a slotted mounting plate for easy height adjustment. Adjust the height position of the fixture by carefully
sliding it up or down as necessary.
1A
Install the Fixture
4
3
6
5
7
6
5
9
8
10
ALLEN WRENCH
& SCREW
MOUNTING PLATE
JUNCTION BOX
SLOT
#8-32 SCREW
4
SOCKET
SHADE
9
3
3
CAUTION: To reduce the risk of a burn or electric shock during re-lamping, disconnect the power to the fixture.