Installation Sheet

1.0

Installation Instructions for

Pitch Wall

700WSPIT_

920WSPITCHD

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product is suitable for wet locations.

This product may be dimmed with a low-voltage electronic

dimmer.

WCALL OLLECTION

Install the Fixture

Remove the two fixture screws from the sides of the

fixture.

Remove the mounting plate from the back of the

fixture.

Attach the mounting plate to the electrical box using

the two provided #8-32 screws.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

MOUNTING PLATE

FIXTURE

SCREW

PAGE 1
920WSPITCHD Installation Instructions for Pitch Wall 700WSPIT_ W ALL C OLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for wet locations. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
1C 5 4 6 4 Connect the ground wire to a suitable ground in accordance with local electrical codes. 5 Connect the white driver wire to the neutral power line with a wire nut. 6 Connect the black driver wire to the hot power line with a wire nut. 7 Properly place the driver, all wires, and wire nut connections into the backplate and secure the fixture to the mounting plate by reinstalling the two fixture screws (reversal of step 1A).