Installation Sheet

Installation Instructions for

920OWQUADO

Install the Fixture

700WSQDR

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for wet locations.

This product may be dimmed with a low-voltage electronic dimmer.

This instruction shows a typical installation.

Quadrate Outdoor

Remove the two fixture screws on the top and bottom

of the fixture.

Remove the mounting plate from the fixture base.

SCREW

Attach the mounting plate to the electrical box using

the two #8-32 screws provided.

MOUNTING

PLATE

MOUNTING

PLATE

SCREW

1.0

OUTDOOR

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

PAGE 1
Installation Instructions for 920OWQUADO Quadrate Outdoor 700WSQDR OUTDOOR GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for wet locations. This product may be dimmed with a low-voltage electronic dimmer. This instruction shows a typical installation.
PAGE 2
1C 1D 4 5 6 4 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes. 5 Connect the white fixture wire to the neutral power line wire with a wire nut. 6 Connect the black fixture wire to the hot power line wire with a wire nut. 7 Properly place all wires and wire nut connections into the electrical box and reinstall the fixture base onto the mounting plate (reversal of step 1A).