Installation Sheet

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product is suitable for damp locations.

Incandescent lamps may be dimmed with a standard

incandescent dimmer. LED lamps may be dimmed with

a LED dimmer. Consult lamp manufacturer for

additional information.

This instruction shows a typical installation.

Installation Instructions for

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with

the construction and operation of the product and the

hazards involved.

Use minimum 90°C supply conductors.

WALL

1.0

SAVE THESE INSTRUCTIONS!

1.0

920WSSPCTCA

700WSSPCT

Spectica Wall

Tech Lighting reserves the right to change specifications for product improvements without notification.

7400 Linder Ave., Skokie, IL 60077

T 847.410.4400 | F 847.410.4500

www.techlighting.com

PAGE 1
920WSSPCTCA Installation Instructions for Spectica Wall 700WSSPCT 1.0 WALL GENERAL PRODUCT INFORMATION: CAUTION - RISK OF FIRE These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is suitable for damp locations. Use minimum 90°C supply conductors.
PAGE 2
Install the Fixture 1A 1 DRIVER 4 6 FIXTURE 2 2 7 3 MOUNTING PLATE FIXTURE SCREW 1 1 Remove the fixture screws located on the top and bottom of the fixture base using a screw driver, then remove the mounting plate from the fixture base. 2 Connect the fixture to suitable ground in accordance with local electrical codes. 3 Connect the white driver wire to the neutral power line wire with a wire nut. 4 Connect the black driver wire to the hot power line wire with a wire nut.